XS Big Dot Installation

[ChillyB]

I first finger-banged my muzzle with some 400 grit paper, evenly all around to preserve the precise pattern of my cylinder bore.

Then I finished it off with drill with a smooshed 12 ga brush with 000 steel wool. Bead post is now smooth and even.

This is a very important step. Your epoxy cannot compete with pellets at velocity. I suspect It'll knock off your sight.

16086856649131317610.jpg (915.83 KiB) Viewed 5997 times

[gWebber]

I’ve often thought about on of these sights, but my barrel has a ribbed back , so the bottom of the sight would need to be flat instead of curved. Wondering if the sight base could be flattened somehow without effecting its usefulness

[Dreadi]

I’ve often thought about on of these sights, but my barrel has a ribbed back , so the bottom of the sight would need to be flat instead of curved. Wondering if the sight base could be flattened somehow without effecting its usefulness

Just buy the right product such as:

https://www.xssights.com/Products.aspx?CAT=8271

[gWebber]

Wondering if the sight base could be flattened somehow without effecting its usefulness

Just buy the right product such as:

https://www.xssights.com/Products.aspx?CAT=8271

Thanks for the tip, I’ll look into that for sure.

[BKinzey]

Nice write-up.