forend slide/tube differences
-
M1AG30
- Valued Shotgunner
- Posts: 101
- Joined: Thu Feb 02, 2012 11:11 pm
- Location: florida USA
- Contact:
forend slide/tube differences
is the forend tube specification the same for all models or are they different? I was thinking of getting another for a few spare forends I have laying around so I do not have to remove the nut and reinstall if I decide to change it up.... any info on this? my current receiver is an express mangnum serial ends in an M
It is their God's decision to forgive our enemies,
It is our duty to arrange the meeting!
It is our duty to arrange the meeting!
-
Banshee
- Guru Shotgunner
- Posts: 400
- Joined: Thu Nov 29, 2012 9:35 pm
- Location: Lost State of Franklin
Re: forend slide/tube differences
Yes there is a difference. New and old style,
Old
New
You can use either one as long as you use the correct bolt slide
viewtopic.php?f=32&t=2463&p=14134#p14134
Old
New
You can use either one as long as you use the correct bolt slide
viewtopic.php?f=32&t=2463&p=14134#p14134
The devil danced as he went down, in the hail of arrows comin' Out on the wild Montana ground, Custer died a-runnin'.
-
Germansheperd
- Senior Shotgunner
- Posts: 245
- Joined: Sat Nov 24, 2018 2:42 pm
Re: forend slide/tube differences
The pre and post ‘85 carrier bolts (cut at the bottom) are different as well.
-
M1AG30
- Valued Shotgunner
- Posts: 101
- Joined: Thu Feb 02, 2012 11:11 pm
- Location: florida USA
- Contact:
Re: forend slide/tube differences
thanks guys for the great info!
It is their God's decision to forgive our enemies,
It is our duty to arrange the meeting!
It is our duty to arrange the meeting!