Remington 870 Repair and Gunsmithing.
I got a 4+1 870 tactical last week and have been trying to decide which method I was going to use to remove the detents from the magazine tube. I have gone back and fourth, talked to Remington and gunsmiths and read every article and watched every you tube video I could find.Finally I decided to drill them out and I am very glad I did. It was quick and easy with no scary moments and it cost me exactly zero. I'm glad the OP was able to ultimately get the tool out of the magazine.
Last edited by efriedrich on Sat Jan 06, 2018 4:01 am, edited 3 times in total.
I used the XS dimple removal tool. Greased up good with Lucas red and tacky and followed the directions. It went well and was able to remove the slug by hand.
Who is online
Users browsing this forum: No registered users and 0 guests