Info request for someone with factory tapped receiver

[safetyfast]

I'm planning to drill and tap my receiver for a picatinny rail. I would appreciate someone measuring the distance from the front of the receiver to the first hole on a factory drilled 870. Thanks.


Sent from my iPhone using Tapatalk

[Banshee]

try this
http://www.rem870.com/2013/10/30/drilli ... ng-sights/

[safetyfast]

try this
http://www.rem870.com/2013/10/30/drilli ... ng-sights/

That's helpful but doesn't provide any measurements.


Sent from my iPhone using Tapatalk

[Synchronizor]

Do you already have the rail you're looking to install?

[safetyfast]

Do you already have the rail you're looking to install?

Yes


Sent from my iPhone using Tapatalk

[Banshee]

Take the measurments from the rail

[Mb1500]

I can take measurements in the A.M. if you still need them.

[safetyfast]

I can take measurements in the A.M. if you still need them.

I do. Thanks.


Sent from my iPhone using Tapatalk

[Mb1500]

From the front of the receiver you're looking at roughly 16.5mm to center.

[safetyfast]

Excellent. Thank you sir.


Sent from my iPhone using Tapatalk