top mount base screws
top mount base screws
So do these need to be installed or can I leave them out. Since I removed them to mount my 429M Top mount base, they seem not to want to thread back in correctly. Here are some pics. I removed the mount due to it was in the way of my Hi-Viz site mount.
- Attachments
-
- 009.jpg (66.83 KiB) Viewed 3343 times
-
- 008.jpg (71.3 KiB) Viewed 3343 times
-
Banshee
- Guru Shotgunner
- Posts: 400
- Joined: Thu Nov 29, 2012 9:35 pm
- Location: Lost State of Franklin
Re: top mount base screws
you can leave them out. The holes may pickup a little dirt.
The devil danced as he went down, in the hail of arrows comin' Out on the wild Montana ground, Custer died a-runnin'.
-
Synchronizor
- Elite Shotgunner
- Posts: 3022
- Joined: Fri Dec 28, 2012 8:04 am
- Location: The Inland Northwest
- Contact:
Re: top mount base screws
You only have to create one thread.
The gun will function fine without those screws in place, but it's not a great idea to leave those holes open if you use your 870 in wet or dirty conditions. If you want to plug those holes when you're not running a top rail, Remington makes smaller set screws that fit flush with the top of the receiver. These are factory-installed in 870s that have tapped receivers, but don't come with rails.
The gun will function fine without those screws in place, but it's not a great idea to leave those holes open if you use your 870 in wet or dirty conditions. If you want to plug those holes when you're not running a top rail, Remington makes smaller set screws that fit flush with the top of the receiver. These are factory-installed in 870s that have tapped receivers, but don't come with rails.
Re: top mount base screws
Thanks, I put the rail back on because the Hi-viz sight was not working for me. I also lost 2 of those little screw and cannot find them. Did you say Remington sells them, I will have to check out there site to see if I can find them.