Lets have some pictures of your builds.

[jermzy]

Here are some pictures of my 870 Police Magnum. It was cerekoted. It has a surefire 618FA forend and a messa tactical side saddle.

[Vitaly]

jermzy, cool shotgun and very nice pics, thanks!

[Wayne]

Remington 870 Police
Remington factory +2 mag extension with factory magazine clamp
Speedfeed stock
Tac Star side saddle
Wilson Combat Ghost ring tritium sights
Surefire forend

rem870.JPG (1.07 MiB) Viewed 7604 times

Remington 870 Police
Remington factory +2 mag extension with factory magazine clamp
Speedfeed stock
Tac Star side saddle
Wilson Combat Ghost ring tritium sights
Surefire forend

[Synchronizor]

You running a Marine Magnum fore-end tube assembly there, Wayne?

[Wayne]

No, just polished it with Flitz. It's slick as snot!

[superhornet]

guess I will add mine to, a Left handed Remington 870, chopped the barrel, added front and rear rifle sights, Leapers Tactical Picatinny Rail Scope Mount, Nordic Components +2 Magazine, phoenix technology kicklite stock, magpul foregrip, weaver to dovetail conversion for rear sight, ( I had to cut the dovetail down to 3/8 inch for the rear sight to fit on it) the conversion part was something like a half inch dovetail, but worked just fine and is super tight, front sight is a flat base ramp (I had to grind the sides down a little bit because it was about an 1/8 inch wider than the the rib vent.) then drill and tap for 6x32 screws, I had to cut them down as well, with a 1/2 inch blade sight. a short barrel for a let handed gun is next to impossible to find so I cut mine down to 18.75 inches.

Hi,

Where did you purchase that front sight and how did you install it on the vented bbl ?
Thanks.

[superhornet]

Here's my R870, it was built in 1988, I bought it used.
BTW does someone know if the quality is any good that year ?





I love that Urbino stock, it does a great job taming the kick.

[Synchronizor]

Here's my R870, it was built in 1988, I bought it used.
BTW does someone know if the quality is any good that year ?

It's an 870. Barring the occasional defect (which is inevitable in any large-scale production operation) they're all good. If all its parts are 1988 or newer, you should have the fully-updated flex-tab action, as well.

[superhornet]

Thanks for your answer, yes i do have the flex tab conversion (U-shaped cut in the lifter), the extractor is non-MIM and the ejector was replaced under warranty a week ago.
I'm all happy.

[Synchronizor]

The bolt and slide assemblies were also modified for the flex-tab update. If you haven't yet, it would be a good idea to check those as well.

What as wrong with the ejector?