Remington 870 Repair and Gunsmithing.
3 posts • Page 1 of 1
trying to put a new forend on my 870 tactical. but the barrel will not budge. i have had a few these guns. never with a barrel this tight. this is a new gun as well? any recommendations. trying to install a new magpul fore end
- Elite Shotgunner
- Posts: 3022
- Joined: Fri Dec 28, 2012 8:04 am
- Location: The Inland Northwest
Are you trying to pull it off with the action open or closed? When the action is closed, the breech bolt assembly and barrel lock together. You should have the fore-end back half-way when pulling the barrel off.
got it off there are some burrs in were the barrel slides in. a little jb blaster goes a long ways.
Who is online
Users browsing this forum: No registered users and 1 guest